7
VINTAGE – Based on* the ubiquitous Celestion Vintage 30, ironically,
used for a more modern tone.
GREEN – Based on* the Celestion Greenback speaker, typically
paired with vintage Marshall
®
Plexi ampliers for a signature classic
rock tone.
CREAM – Based on* the Celestion G12M-65, a higher powered
version of the ceramic C12N with a brighter top end.
JARVIS – Based on* the Jensen
®
P12Q, often paired with Fender
®
amps for great rich and full clean tones.
BAYOU – Based on* the Eminence Swamp Thang Patriot Series,
which provides big aggressive bottom end with classic American
tone, perfect for blues and jazz.
ESSEX – Based on* the Blue Bell speakers often paired with Vox
®
ampliers and Class A style amps for a "chimey" tone.
HF OFF – This is the natural sound and feel of the speaker in the
Powercab device with the high-frequency compression driver
disabled and no EQ of any kind applied.
Powercab 112 Plus Presets
A preset allows you to store and recall your complete speaker tone,
which consists of the Speaker Mode in use (Flat, Speaker, or IR), its color
and parameter settings. To change presets, turn the Select Knob. To
edit a preset, press the Select Knob. Presets can also be selected or
automated via L6 LINK or MIDI - please see these respective sections.
Preset Parameters
MODE - Selects between the three supported modes, Flat, Speaker or
IR, and provides access to available mode parameters.
FLAT MODE - Essentially full-range, at-response, and equivalent
to the signal being sent to a front-of-house mixer. This mode is
most helpful for simple plug-and-play compatibility, letting your amp
modeler do all the work.
Voicing – Selects the nal post-processing EQ and crossover
settings for the speaker system.
FRFR - Uses the high-frequency compression driver with a
attened frequency-response EQ for full-range operation.
LF Solo - Uses only the woofer with no EQ applied, allowing it
to be utilized like a typical guitar speaker.
LF Flat - Uses only the woofer with a attened frequency
response EQ. This voicing is used for the Speaker Mode.
SPEAKER MODE - Intended to respond like a real guitar speaker
for a traditional "amp-in-the-room" experience. This mode applies
dierent tonal characteristics of the selected speaker model to the
device's coaxial driver, with the following 3 adjustable parameters.
Speaker Model - Selects which speaker model is being applied.
DI Mic Model - Selects the microphone model that is applied to
the XLR output signal while in Speaker Mode, intended to emulate
placing the selected mic type in front of the Powercab 112 Plus
active guitar speaker system.
Mic Distance - Sets the distance between the simulated
microphone and the simulated cabinet.
*All product names used within this document are trademarks of their respective owners, which are in no way associated or aliated with Line 6. These
trademarks of other manufacturers are used solely to identify the products of those manufacturers whose tones and sounds were studied during Line 6’s
sound model development. Celestion is a registered trademark of KH Technology Corp. Eminence is a registered trademark of Eminence Speaker, LLC.
Marshall is a registered trademark of Marshall Amplication Plc. Jensen is a registered trademark of Electronics Trademark Holding Company LLC. Vox is a
registered trademark of Vox R&D Limited.
To Next Page
Loading...
Need help?
General