RELAY G10T Wireless Charging and Syncing*
1. Insert the RELAY G10T transmitter into the INPUT JACK. SPIDER V will
nd and select the best available channel and charge the transmitter.
2. After a few seconds a check mark will appear on screen to show
the transmitter is ready to use. Remove RELAY G10T and plug it
into your guitar.
3. The battery life is also indicated on the Home Screen when the
RELAY G10T is detected. When showing 3 bars, the battery is full.
4. SPIDER V must be plugged in to power and turned on in order to
charge the transmitter.
Editing
1. Press the EDIT BUTTON.
2. Turn the ROTARY KNOB to scroll thru the parameter list.
3. Press the ROTARY KNOB to select a parameter.
4. Turn the ROTARY KNOB to modify the parameter.
5. Press the ROTARY KNOB again to return to scrolling the list.
6. Press the HOME BUTTON to exit.
Global Settings and Wireless Channel Selection
1. Press and hold the HOME BUTTON to enter the Global Settings
Screen.
2. Turn the ROTARY KNOB to scroll through the settings
3. Press the ROTARY KNOB to select a setting.
4. Turn the ROTARY KNOB to modify the setting.
5. Press the ROTARY KNOB again to return to scrolling the list.
6. Press the HOME BUTTON to exit.
Using FBV Foot Controller
1. Plug in a Line 6 FBV controller into the FBV PEDAL port on the
back of SPIDER V.
2. Press Bank UP/DOWN and A,B,C,D to change presets
3. Press the second row of footswitches to control eect bypass.
Please refer to the Pilot's Guide for your FBV, or the Line 6 website
for additional details and functionality.
4. Press the TREADLE toe switch to engage the wah eect.
5. Press the FUNCTION BUTTON to trigger the looper record,
overdub and playback.
*Available on select models. Please see the comparison chart to see
which features are on each model of Spider V.
To Next Page
Loading...
Need help?
General
