This readout indicates the settings of the PJ7. To make a change you will need to enter one of
the commands to manipulate the interface. The commands have a specific format and must be
followed otherwise the command will not execute.
Commands:
0 - Recall the settings of the PJ7 Format: [0]
1 - Set the PJ7 Microphone Level from 00 - 99 Defaults: 05
Format: [1 xx] where xx ranges from 00 to 99
2 - Set the Hand Microphone Level from 00 - 99 Defaults: 10
Format: [2 xx] where xx ranges from 00 to 99
3 - Configure Volume Control Actions: Defaults: 0, 0, 0
Format: [3 x y z] where
x = 0: Speaker output is Pre-Volume Pot, non-adjustable volume
x = 1: Speaker output is Post-Volume Pot, adjustable volume
y = 0: Volume is controlled from the PJ7 internally
y = 1: Volume is externally controlled from USB HID commands
z = 0: Headphone Mute is handled internal to the PJ7
z = 1: Headphone Mute is controlled from USB HID commands
4 - Initial Volume for the PJ7 Headset: Defaults: 128
Format: [4 xxx] where xxx ranges from 000 to 255
5 - Initial Volume for the Line-Out/Speakers: Defaults: 128
Format: [5 xxx] where xxx ranges from 000 to 255
6 - Minimum volume level for the PJ7 Headset: Defaults: 005
Format: [6 xxx] where xxx ranges from 000 to 255
7 - Maximum volume level for the PJ7 Headset: Defaults: 250
Format: [7 xxx] where xxx ranges from 000 to 255
8 - Minimum volume level for the Line-Out/Speaker: Defaults: 005
Format: [8 xxx] where xxx ranges from 000 to 255
9 - Maximum volume level for the Line-Out/Speaker: Defaults: 250
Format: [9 xxx] where xxx ranges from 000 to 255
A - Reset settings to defaults Format: [A YES]
This command will reset all values to defaults which is the same as a Power-up Condition
To Next Page
Loading...