43
Appendix C PC And Server Configuration
Linksys
3. Click Next when the New Scope Wizard Begins.
4. Enter the name and description for the scope, click Next.
5. Define the IP address range. Change the subnet mask if necessary. Click Next.
Figure 50: IP Address Screen
6. Add exclusions in the address fields if required. If no exclusions are required,
leave it blank. Click Next.
7. Change the Lease Duration time if preferred. Click Next.
8. Select Yes, I want to configure these options now, and click Next.
9. Enter the router address for the current subnet. The router address may be
left blank if there is no router. Click Next.
10. For the parent domain, enter the domain you specified for the domain
controller setup, and enter the server’s address for the IP address.
Click Next.
Figure 51: DNS Screen
11. If you don’t want a WINS server, just click Next.
12. Select Yes, I want to activate this scope now. Click Next, then Finish.
13. Right-click on the server, and select Authorize. It may take a few minutes
to complete.
To Next Page
Loading...