Chapter 1
Product Overview
2
Media Hub
Chapter 1
Product Overview
2
Media Hub
Front Panel of the Media Hub (NMH300
Series)
DISK 1 (Blue/Red) The DISK 1 LED serves two
purposes. The LED is solidly lit blue when Disk 1
is ready for use. The LED is not lit when no disk
is detected.
DISK 2 (Blue/Red) The DISK 2 LED serves two
purposes. The LED is solidly lit blue when Disk 2
is ready for use. The LED is not lit when no disk
is detected.
Back Up Button To initiate backup jobs
specified by the backup software on your
computer(s), press the back up button.
NOTE: The back up button only
supports Windows computers
installed with the backup software.
NOTE: Your computer(s) must be
powered on for the jobs to run.
Power Button and LED (Blue/Red) To power
on the Media Hub, press the Power button.
To shut down the Media Hub, press and hold
the button until the Power LED starts flashing
(this may take more than three seconds). A
complete shutdown may take 10-15 seconds.
The Power LED flashes blue when the
Media Hub boots up, installs a disk, or shuts
down. It is solidly lit blue when the Media
Hub is ready for use. The LED flashes either
blue or red when there is an error. (Refer to
Appendix A: Troubleshooting, page 51.)
NOTE: If the Media Hub must be shut
down for a long period of time, Linksys
recommends that you disconnect the
power adapter from the Media Hub.
USB The USB port connects to a USB storage
device.
Back Panel
Both series of the Media Hub share the same back panel.
Air Vent The air vent allows air to circulate and
cool the Media Hub.
WARNING: Do not block the air
vent on the back of the Media Hub;
otherwise, overheating can occur.
To Next Page
Loading...
