Linksys WRT54G3G-ST - Figure 6-2: Select Service Screen; Figure 6-3: Disconnect the Modem from the Computer Screen

28
Chapter 6: Setting up the Wireless-G Router for Broadband WAN Service Only
Using the Setup Wizard
Wireless-G Router for Mobile Broadband
3. Click the Broadband WAN Only radio button to configure the Router for broadband WAN service. Make sure
the Router is powered off.
4. Disconnect the Ethernet network cable from your computer. (This is the cable that connects the computer to
your modem.) Then click the Next button.
Figure 6-2: Select Service Screen
NOTE: If you click the Mobile Broadband radio button to configure the Router for mobile broad
service only, go to “Chapter 5: Setting up the Wireless-G Router for Mobile Broadband Service.”
If you click the Broadband WAN and Mobile Broadband radio button to configure the Router
for broadband WAN and mobile broadband service, go to “Chapter 7: Setting up the Wireless-G
Router for Broadband WAN and Mobile Broadband Service.”
Figure 6-3: Disconnect the Modem from the Computer
Screen