Linksys WVC54GCA-RM - Wireless-G Internet Home Monitoring Camera Network - Page 4

The Wizard searches for the
Wireless-G Internet Home
Monitoring Cameras on your
network, then displays the
Camera found along with status
information.
If the Camera you want is not
displayed, click Search Again to
run a new search for Cameras.
Otherwise, in the Camera List box,
click the name of the Camera you
are currently installing. Write down
the IP address of the Camera, so
you can use it to access the Web-
based Utility later. Click Next.
Enter a name for the Camera.
Memorable names are helpful,
especially if you are using multiple
Cameras on the same network. It
should have 15 characters or fewer.
After you have entered the name,
click Next.
Select how to assign an IP Address
to the Camera, either automatically
or manually. Then click Next.
Automatically obtain an IP
Address Select this option if you
want to automatically assign an IP
address to the Camera using DHCP.
If you are not sure which option to
choose, Linksys recommends this
option.
I.
J.
K.
Automatically Assign IP Address Using DHCPAutomatically Assign IP Address Using DHCP