EasyManua.ls Logo

Linksys X6200 - Page 187

Linksys X6200
889 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.
IPoE RFC 2684 Bridged------If selected, enter the correct data for the IP
Settings. Select Obtain an IP address automatically if your ISP allocates
an IP address upon connection. Otherwise, select Use the following IP
address.
3.
IPoA RFC 2684 RoutedWith this method, you are required to use a
permanent IP address to connect to the Internet.
4.
RFC 2516 PPPoE------Some DSL-based ISPs use PPPoE (Point-to-Point
Protocol over Ethernet) to establish Internet connections. If you are using
PPPoE, your IP address is provided automatically.
5.
RFC 2364 PPPoASome DSL-based ISPs use PPPoA (Point-to-Point
Protocol over ATM) to establish Internet connections. If using PPPoA, your
IP address is provided automatically.
Network SetupThe Network Setup section configures the IP settings for your local
network.
DSL mode (PTM/VDSL)
VDSL2 ProfilesSelect VDSL2 profiles supported by your ISP. Default is Auto
(recommended).
Enable VLANThe modem router will tag specific VLAN numbers to all outgoing traffic
through the WAN interface. Please contact your ISP to get this information.
VLAN IDYou will need to enter a VLAN ID once VLAN is enabled. The ID range is from 10
to 4095. Please contact your ISP for your specific setting.
Internet Setup--The Internet Setup section configures the router to your Internet
connection. Most of this information can be obtained through your Internet Service
Provider (ISP).
Internet Connection Type
Select the type of Internet connection your ISP provides from the drop-down
menu. The available types are:
1.
Bridged Mode OnlyIn this mode, only the DSL modem function is
available, and all Gateway features are disabled.
2.
IPoEIf selected, enter the correct data for the IP Settings. Select Obtain
an IP address automatically if your ISP allocates an IP address upon
connection. Otherwise, select Use the following IP address.
3.
PPPoESome DSL-based ISPs use PPPoE (Point-to-Point Protocol over
Ethernet) to establish Internet connections. If you are using PPPoE, your IP
address is provided automatically.
15

Table of Contents

Related product manuals