SAFETY WARNING
The digital photo frame should be used indoors only.
Use a DC 9.5V/3A power adapter.
To reduce the risk of fire of electric shock, do not expose this appliance to the rain or moisture.
Do not block the ventilation holes on the back of the digital photo frame at any time.
Keep your digital photo frame out of sunlight. Direct sunlight may cause damage.
Do not splash or fill the digital photo frame with liquids.Keep clear of liquids.
Keep the LCD screen clean and treat it gently. Avoid touching the LCD directly.
If you need to clean the LCD screen, please make sure the digital photo frame is switched off
and the mains cable unplugged . And then use a soft cloth and spray the solutions on the soft
cloth first(Use only LCD specific cleaner).
Always position the digital frame on a suitable and level surface.
The digital frame only complies with the voltage type specified on the back.
Working Conditions:
Operating Temperature: 0 C～ +45 C
Humidity:20%～ 80%
For an environmentally friendly operation and to save gently,please switch off the mains
supply when the digital photo frame is not in use.
In order to prevent damage to the memory card or the digital photo frame, please switch off
your digital photo frame before removing or inserting your memory card.
About the built- in Polymer Li Battery:
1.Plug the AC plug of adapter into standard power socket and the other DC output plug
into the machine socket labeled with DC 9. 5V. The recharge will start without any
interference to the frame's operation.
2. It takes approx about 4- 5 hours to fully recharge. To optimize the service life of the
battery,the duration of recharging should be less than 8 hours.
3.The rechargeable battery discharges gradually when not in use and after approximately
one month the battery will be fully discharged.
About The Rechangable BatteryAbout The Rechangable Battery
To Next Page
Loading...