‑ 6 ‑EN
• Do not use the changing unit when any part is broken, torn or missing.
• Be aware of the risk of open res and other sources of strong heat, such as
electric bar res, gas res etc. in the near vicinity of the changing unit.
Assembly instrucon
1.
Take the travel baby bed out of the bag and loosen the adhesive straps.
Place the bed on the oor and put the bag aside (see g. 1).
2. Separate the legs pulling them apart. Keep the central lock up. Otherwise
handrails will not t in the right place (see g. 2).
Note! So that the sides of the cot / handrails are properly blocked, the central
blockade of the oor must be raised upwards. The baby rails will not lock when
the oor is unfolded.
3. Pull the middle part of each top rail covered with material so that they t
into place. Start with the longer rails, and then the shorter ones (see g. 3).
4. Push the middle lock unl the surface is completely at (you will hear the
click sound) (see g. 4).
Base installaon
Mount the plaorm with the zipper (g. 5). Secure the zipper by fastening the
clasp (see gure 5a). Connect the sening pipes located at the boom of the
plaorm together (Fig. 6). Place the maress on a plaorm and connect it to the
plaorm with Velcro.
Changing table assembly instrucon
Push the buon marked on g. 7 and connect short and long sening tubes of
the changing table. Install the plasc fastening elements on the long and short
sides of the bed.
Organizer installaon
Put the hooks on the organizer and mount it on the bed frame.
Baby bed folding instrucon
1.
Remove all the bed accessories. Remove the maress, canopy, organizer
and all the other accessories. Grasp the centre handle located in the middle
of the oor and pull it up.
2. To unlock the upper rails, press the indicated buons on each side of them.
Pull it slightly up and then push it down. Unlock the shorter sides rst, and
then do the same with the longer ones.
To Next Page
Loading...
