Lionelo Levi One - Groups II and III - assembly without child safety seat backrest; How to maintain and clean

‑ 12 ‑EN
Groups II and III – assembly without child safety seat backrest
If the height of the child’s head is above the headrest (at maximum height), it is
necessary to disassemble the backrest of the child safety seat.
1. Push the backrest of the child safety seat as presented in the g. 15a.
2. Detach the backrest of the child safety seat from the base (g. 15b).
3. Place the base on the car seat (g. 15c).
4. Put the child on the child safety seat base.
5. Pull the car safety belt out. Carry it through elbow rests (g. 16a and 16b).
6. Fasten the car safety belts (g. 16c).
How to maintain and clean
The cover can be cleaned in warm water with the use of soap or so detergent.
Do not dry the cover in the sunlight. The buckle, child safety seat belts and plasc
elements must be washed with warm water. Do not use strong detergents. If you
do not use the product, please store it in a dark and dry place, away from sunlight.
The pictures are for reference only. The real design of the products
may dier from the pictures presented.
The product meets the requirements of the ECE R44.04 standard