Lionelo Whizz - Usage Restrictions and Load Limits; Product Components and Installation; Component Identification; Assembly Instructions

‑ 4 ‑EN
10. Please get familiar with the manual supplied by the manufacturer.
11. Maximum permissible load is 100 kg (A class). The product is intended for
children above the age of 8.
12. The product is not intended for extreme sports.
13. Do not hold sharp items while riding.
14. When a child uses the scooter, please monitor riding at all mes.
COMPONENT OF THE SET (FIG. 1)
A. Shank with handlebars
B. Plaorm with wheels
C. 2x Hex key
HOW TO INSTALL
1. Insert the shank with handlebars into a dedicated hole (g. 2).
2. Tighten up screws (D in g. 2) with the use of hex key supplied. Make sure
wheel and handlebars are properly posioned (g. 3).
3. Check fastening of the product. If bolts are stable, the scooter is ready for
use. If not, please ghten them up.
HOW TO USE
To start riding, put one foot on the plaorm, grab the handlebars with two palms
and choose riding direcon. Push o from the surface with your second foot to
move. To change riding direcon, gently turn handlebars as desired. Try your rst
ride in the open space, devoid of obstacles.
HOW TO BRAKE
Press the rear mudguard with a le or right foot and simultaneously shi your
weight to the back. Adjust the center of gravity while stopping to avoid falling
down. Note! The mudguard may get very got – make sure you do not get burnt.
HOW TO REPLACE WHEELS AND MAINTAIN BEARINGS
If you can see that wheels are worn out, think about replacing them. Use the hex
key to unscrew the bolt which aaches the wheel to the scooter frame. Remove
the mounng mandrel and then wheel. If the technical condion of bearings is
good, keep them for another installaon. To do so: remove bearings, clean them