5. Safety regulations
The operation of machines containing rotating or moving tools
always bears risks. Therefore, you should always follow the safety
regulations:
• Before starting operation, the personnel must have read the
operating and safety instructions and observe them.
• Never remove or alter the safety devices!
• Do not touch rotating or moving parts!
• Never lie down beneath the unit for repair or control purposes
when the unit has not been carefully secured beforehand!
• Only use universal joint shafts in perfect condition and with
overload protection!
• For maintenance work switch off the device!
• Do not exceed the prescribed speed (540 rpm) when operating
the unit!
• Maintain safety distance! (Attach danger sign on the side of the
machine)
Attention!
Do not enter the working area when the universal joint shaft
is rotating! In case of contact there is an increased risk of
accidents. For your own safety, do not wear wide or loose
clothes (e.g. scarves)!
• Any work, maintenance and repair on the LIPCO Reversing
Harrow must be carried out by persons who are familiar with the
unit and have been informed about possible risks!
To Next Page
Loading...