Lippert Components ground control TT - Installing Leveling Sensors

Rev: 11.13.2017 Page 12
Ground Control TT Leveling OCTP Owner's
Accessing the OneControl App
1. Ensure there is power to the trailer's wireless network.
2. Navigate to the device's (smart phone, tablet, etc.) wifi settings. Turn wireless feature on and connect to
the myRV wireless network.
NOTE: If this is the first time connecting to the myRV wireless network, a password will be required. The
password is located on the trailer's wifi hub (Fig. 10).
3. Open the OneControl application on the compatible device.
NOTE: If the device states "Unresolved Network Connection," retry
connecting to the myRV wireless network and/or wait for the
connection to resolve and display "Connected" under the myRV
wireless connection.
4. The application will request the user "Agree" to an end user license
agreement, create a PIN and "Re-enter PIN to confirm."
5. On “Initial Setup” choose “myRV” (Fig.11A).
6. The OneControl app will now display all functions.
Operation - OneControl App From myRV
Fig. 10
Fig. 11
Basic Jack Operation In Standard Mode
To reach Standard Mode (Fig. 9) for leveling:
1. Power on the OneControl Touch Panel App.
2. Press the "Leveler" icon (Fig. 12A).
3. The screen will show the system menu (Fig. 9) for Standard Mode. The Power Tongue Jack can be
extended/retracted in Standard Mode. Front and rear jacks cannot be operated in Standard Mode.
Fig. 12
A
Be sure to park the trailer on solid and level ground. Prior to operation, clear all jack landing locations
of debris and obstructions. The locations should also be free of surface depressions and moisture. When
parking the trailer on extremely soft surfaces, utilize load distribution pads under each jack.
A