Lippert Components ground control TT - System Operation

Rev: 11.13.2017 Page 16
Ground Control TT Leveling OCTP Owner's
Configuring Linc Remote to Sync to The One Control Touch Panel
1. Turn on the Linc™ remote control (Fig. 14I) and enter a PIN.
2. Choose "Leveler" from the menu screen.
3. Turn on the OneControl Touch Panel (Fig. 4L).
4. On the OneControl Touch Panel, press the "CONNECTED" icon at the top of the screen (Fig. 15A) quickly 6 times.
Wait a few seconds until the gear icon with "OPTIONS" appears (Fig. 16A).
NOTE: If configuring to the OneControl App, press the "OPTIONS" button.
5. Press the gear icon with "OPTIONS" (Fig. 16A).
6. Use the "UP" and "DOWN" arrows (Fig. 16B) to scroll to "WIRELESS CONFIG" (Fig. 7).
7. Press "ENTER" (Fig. 17A). The screen will display "Wireless Configuration Press any Linc button to Sync"
(Fig. 18).
8. Press any button in "Leveler" mode on the Linc Remote Control (Fig 14).
9. Pressing "ABORT" on the OneControl Touch Panel (Fig. 18A) will cancel configuration sequence.
Fig. 15
Fig. 16
Fig. 17
Fig. 18
A
A
B
A
A
Basic Jack Operation
• Press "EXTEND" ( Fig. 14E) or "RETRACT" (Fig. 14A). Press "FRONT" arrow (Fig. 14B) to operate Power
Tongue Jack.
• Press "AUTO LEVEL" (Fig. 14H) to start auto level sequence.
• If the OneControl Touch Panel is in Manual Mode, to operate jacks, press "EXTEND"
(Fig. 14E) or "RETRACT" (Fig. 14A) button, then press the "LEFT" (Fig. 14C), "RIGHT" (Fig. 14F), "FRONT" (Fig.
14B) or "REAR" (Fig. 14G) button depending on which pair of jacks need to be operated.
Unhitching From A Tow Vehicle
NOTE: Prior to unhitching from the tow vehicle, ensure trailer is parked on a level surface and chock the tires of the
trailer.
Be sure to park the trailer on solid and level ground. Prior to operation, clear all jack landing locations
of debris and obstructions. The locations should also be free of surface depressions and moisture. When
parking the trailer on extremely soft surfaces, utilize load distribution pads under each jack.
Operation - Linc Remote