Lippert Components PROJECT 2000 TOPLINE BEDLIFTING PLUS - Setting Additional Positions; Exiting Programming Mode

Rev: 10.16.20 Page 3 CCD-0003782
As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you
have any questions, please do not hesitate to contact us at (574) 537-8900 or by email at customerservice@lci1.com. Self-help tips,
technical documents, product videos and a training class schedule are available at lci1.com or by downloading the MyLCI app.
PROJECT 2000
®
TOPLINE BEDLIFTING PLUS
PROGRAMMING STOP POSITIONS (EU)
TI-360
POWER AND MOTION
NOTE: If data is stored without having reached the end-of-stroke position first, the red warning light
(Fig.1F) will turn on and will remain on until the buttons are pressed.
7. To set other stop positions, move the bed with the UP and DOWN buttons then repeat step 6 to store
the other positions.
NOTE: It is not necessary to store stop positions in sequence, since the controller will sort
themautomatically.
8. To exit the programming mode at any time without setting five stop positions, press and hold the UP
button (Fig. 1B) and then press the hidden (NULL) button (Fig. 1C).
NOTE: If five stop positions are stored, the controller will automatically exit the programming mode.
9. Data are sorted in a sequence in the memory before exiting the programming mode.
A. The green light (Fig. 1E) will turn off indicating programing operations are done.
B. The controller is now ready for use.