Lippert Components Siphon 360 User Manual

Rev: 07.11.18
Page 3
CCD-0001584
Installation
1. Dry fit the vent cap on the roof vent prior to adding adhesive to the 360 Siphon® (Fig. 1).
2. If using the water funnel (Fig. 2), snap it in place into the underside of the 360 Siphon®.
NOTE: The funnel channels excess moisture into the holding tanks. The funnel aids in protecting the roof
surface from moisture and helps ensure a tight seal if the pipe is not cut straight.
3. Apply OEM-supplied butyl tape or sealant to the bottom flange of the 360 Siphon® to seal the
assembly to the roof.
4. Set the 360 Siphon® over the stack pipe and secure it to the roof with 4 OEM-supplied fasteners.
5. Cover fastener holes with OEM-supplied sealant per RVIA standards.
Fig. 1
Fig. 2

Lippert Components Siphon 360 Specifications

General

Brand	Lippert Components
Model	Siphon 360
Category	Fan
Language	English