Rev: 08.18.20 Page 2 CCD-0003685
TI-353
SOLERA
®
POWER AWNING REGAL HEAD
SPEAKER REPLACEMENT
AWNINGS
Fig. 3
Underside of Speaker Grill Cover
Instructions
The following instructions apply to the drive and idler heads with speakers.
Removal
1. Extend the awning about 12" away from the unit.
Fig. 2
Failure to secure the outer arms may result in personal injury, product or property damage.
Pressure from the gas strut can cause the outer arm to kick open, which could cause injury, product
or property damage.
2. Secure both support arm assemblies by running a zip tie around the outer arm and around the pin on
the top of the mount arm where the mount arm and inner arm connect (Fig. 2).
3. Use a putty stick or similar tool to slide in between the grill cover and main body of the head cover.
Start in one corner and work your way around the grill cover (Fig. 3) until all four sides have been
released. Set aside for later use.
NOTE: Grill cover attaches with plastic tabs.
To Next Page
Loading...
