Lippert 3000 Series - Page 25

Rev: 10.18.21 Page 25 CCD-0004098
Fig. 62 Fig. 63
A
A
B
B
5. Lower the side and front gate patio panels (Fig. 58A) down towards the surface of the ramp door
(Fig. 58B) and flip the front and gate patio panels (Fig. 59A) over the top of the side panel (Fig. 59B).
Fig. 58
7. If applicable, disengage the J-Bolt (Fig. 3) on the curbside of the patio railing.
8. For the curbside patio railing (Fig. 61B), swing the front panel (Fig. 61A) out in-line with the side patio
railing (Fig. 61B).
9. Drop the side and front patio panels (Fig. 62A) down towards the surface of the ramp door (Fig. 62B),
then flip the front patio panel (Fig. 63A) over the top of the side panel (Fig. 63B).
A
B
C
Fig. 59
B
A
A
Fig. 60
B
A
Fig. 61
B
6. Located towards the top of the ramp door, release the curbside front panel bottom leg (Fig. 60A) from
the keeper (Fig. 60B) by pushing the compression latch lever (Fig. 60C) towards the coach and slide the
leg out from the keeper.