Lippert 3000 Series - Page 19

Rev: 08.18.21 Page 19 CCD-0004099
Fig. 38
NOTE: On alternate versions of the Lippert 3000 series patio rail kit, there will NOT be two front and rear
bungees. An alternate version of the Lippert 3000 Series will have a J-bolt (Fig. 39A) located at both side
patio railing front bases (Fig. 40A). Pull the yellow lanyard (Fig. 39B) and turn the J-bolt a quarter turn
(Fig. 39C). Raise the side patio rails into a 90 degree position (Fig. 40B) until it clicks into the J-bolt,
locking the patio rail into position. The J-bolt also holds the side rail panel down and in place when the
yellow lanyard is pulled out, turned a quarter turn and the patio railing is folded down into the stowed
position (Fig. 38). The bungee cords (Fig. 38A) located at the front of the patio rail assembly's now serves
the same purpose.
5. Unhook the bungee (Fig. 38A) from the front driver's side and curbside brackets (Fig. 38B), holding the
patio railings to the ramp door.
Fig. 39 Fig. 40
A
B
C
A
B
A
A
B
B