Rev: 08.18.21 Page 20 CCD-0004099
7. If applicable, engage the J-bolt (Fig. 39) on the curbside of the patio railing.
8. For the curbside patio railing (Fig. 42A), fold the front panel (Fig. 42B) over towards the top of the ramp door.
9. Lift the patio railing up into a 90 degree position (Fig. 43A).
10. Swing the front panel in towards the center of the ramp door (Fig. 44A).
6. Release the two snaps holding the front panel and gate to the driver's side railing (Fig. 41A) and one snap
on the curbside railing (Fig. 41B).
NOTE: An alternate version of the patio rail kit has a "no-gate" option which there will only be one snap on
each side holding the two front panels to the side panels.
Fig. 41
A/B
A
A
B
Fig. 42 Fig. 43
B
Fig. 44
A
A
A
To Next Page
Loading...