Lippert 3000 Series - Page 33

Rev: 08.18.21 Page 33 CCD-0004099
9. If applicable, disengage the J-bolt(Fig. 86) on the curbside of the patio railing. For the curbside patio
railing (Fig. 93A), swing the front panel (Fig. 93B) out in-line with the side patio railing (Fig. 93A).
10. Lower the side and front patio panels (Fig. 94B) down towards the surface of the ramp door (Fig. 94A)
and flip the front patio panel (Fig. 95B) over the top of the side panel (Fig. 95A).
11. Attach the two snaps holding the front panel and gate to the driver's side railing (Fig. 96A) and the one
snap holding the front panel to the curbside railing (Fig. 96B).
NOTE: An alternate version of the patio rail kit has a "no-gate" option which there will only a one snap on each
side holding the two front panels to the side panels.
Fig. 93
A
B
B
Fig. 94
A
B
Fig. 95
A
Fig. 96
A/B
A
B
A