TME-104P-CSR-LX800-R1V5.doc Rev 1.5 16 (44)
Display Voltage Jumpers
Jumper LVDS and Backlight
Connector type:
IDC6, 2.00 mm.
Use a 2 mm jumper between 1-3 or 3-5 to select the backlight voltage.
Use a 2 mm jumper between 2-4 or 4-6 to select the display voltage.
Pin
Signal Pin
Signal
1 +12 volts 2 +5 volts
3 Backlight voltage 4 Display voltage
5 + 5 volts 6 +3.3 volts
Backlight
Jumper 1-3 3-5
Power supply +12V +5V
LVDS
Jumper 2-4 4-6
Power supply +5V +3.3V
Note An arrow on the PCB marks Pin 1
3.4 EIDE Solid State Drive
On the top side of the board, the SSD is mounted. It can be used instead of a hard disk. Per default,
it is defined as master but that can be changed in BIOS.
The SSD, manufactured by SST, is built as a flash storage organized of Single Level Cells (SLC). It
can be erased over 100.000 times without losing capacity. The wear-leveling feature can increase
that number, depending on the allocation of the disk space.
Product features:
Read Bandwidth 30 Mbytes/s
Write Bandwidth 10 Mbytes/s
Access time 0.2 ms
PATA Compatibility ATA-5; PIO 0-4; DMA 0-2; UDMA 0-4
Power Control Automatic power down during wait periods
Automatic sleep mode during host inactivity
NAND Management Active wear-leveling algorithm
default
um
er settin
To Next Page
Loading...