TME-104P-CSR-LX800-R1V5.doc Rev 1.5 18 (44)
3.6 On Board Power Supply
The on board power supply generates all necessary voltages from the single supply voltage of 5
volts. The generated 3.3 volts are available on the connectors "Flat Panel" and "LVDS".
Note This 3.3 V must not be used to supply external electronic devices with high
power consumption like other PC/104 boards or displays.
Power Connector
Connector type JST B15B-EH-A 15 pin
Adapter cable
available, art.no 862-0044-10
Pin Signal (standard) Signal (5V only)
1 +5V +5V
2 GND GND
3 +5V +5V
4 GND GND
5 +5V +5V
6 n.c. n.c.
7 GND GND
8 GND GND
9 n.c. n.c
10 n.c. n.c
11 GND GND
12
+12V (only for PC104 slot
and backlight power
supply)
n.c
13
+12V (only for PC104 slot
and backlight power
supply)
n.c
14 GND GND
15 -12V (only for PC104 slot)
n.c
Note The default cable adapter supports the connection of
±
12V power supply.
If the 5V only power supply is required leave these pins open.
The board can also be supplied over PC/104- or PC/104 plus bus.
To Next Page
Loading...