TME-104P-CSR-LX800-R1V5.doc Rev 1.5 25 (44)
3.14 Speaker
The speaker signal is located on the IDC10 Header PS/2. A standard PC
Speaker can be connected between the signal SPEAKER and VCCKB.
Connector type
IDC10 pin header 2.54 mm
Pin
Signal Pin
Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Standby
9 Ext. Battery 10 Power Button (default)/
Reset-In
3.15 External Power-Button
The Power-Button signal is located on the IDC10 Header PS/2. To power up/down the board the
signal Power-Button must be pulled to GND. It is not available in standard configuration.
Connector type
IDC10 pin header 2.54 mm
Pin
Signal Pin
Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Standby
9 Ext. Battery 10 Power Button
To Next Page
Loading...