Lippert Solera 5000 Series - Securing the Fabric

Rev: 06.01.23 Page 10 CCD-0007029
Securing the Fabric
Secure the fabric with to the awning rail using ONE of the two options listed below. In option 1 the screw
will go through the fabric and polycord, while in option 2, the screw will only go through the awning rail.
NOTE: Before securing the fabric, extend and retract the room several times to ensure that the fabric is
square on the roll tube.
Option 1
Secure the fabric (Fig. 19A) in the awning rail (Fig. 19B) no more than 1" inside the edge of the fabric on both
ends using an OEM supplied #6 x 1/2" hex head screw (Fig. 16C). Install the screw (Fig. 19C) down through
the awning rail (Fig. 19B) into the fabric (Fig. 19A) and the polycord (Fig. 19D).
Option 2
Secure the fabric (Fig. 19A) in the awning rail (Fig. 19B) no more than 1/4" outside the edge of the fabric
on both ends using an OEM supplied #6 x 1/2" hex head screw (Fig. 19E). Install the screw (Fig. 19E) down
through the awning rail (Fig. 19B).
1"
1/4"
OR
Outer Edge
of Fabric
A
D
C
E
Fig. 19