Rev: 06.01.23 Page 2 CCD-0007029
TABLE OF CONTENTS
Introduction 2
Safety 3
Resources Required 3
Prior to Installation 4
Installation 4
Installing the Awning Rail 4
Assemble the Extension Rod and Cap 5
Installing the Solera Slide Topper Access Plate 5
Installing the Solera Slide Topper Access Bracket 7
Installing the Solera Slide Topper Assembly 7
Installing the Access Bracket Screw Cover 9
Securing the Fabric 10
Option 1 10
Option 2 10
Slide Topper Check List 11
Introduction
The Solera® 5000 Series Slide Topper is a high-quality, cost-effective way to help keep slide-outs free of dirt,
leaves and debris. The Solera® Slide Topper is permanently attached to the slide-out and retracts/extends
with the room.
The Solera Slide Topper Access Plates are being utilized by specific OEMs for prepping the unit to make
installing the Solera Slide Topper quicker and easier.
The Solera® 5000 Series Slide Topper comes complete with mounting hardware. If the unit came with a
pre-installed Solera® Slide Topper Access Plate (Fig.1A or Fig.2A), the access plates, part number 768004
(black) or 768005 (white) will not be needed for this installation.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/solera-slider-awning.
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
To Next Page
Loading...
