Rev: 06.01.23 Page 6 CCD-0007029
B. If installing on the T-molding, start on one side of the front of the slide-out by placing one of the
two access brackets (Fig. 7A) at the very bottom corner of the T-molding, (Fig. 7B) as close to the
outside of the T-molding as possible without going over the corner mold (Fig. 7C).
NOTE: Make sure the screws do not go over the roof line.
2. Use silicone sealant or butyl tape on the back of the plate prior to installing.
Fig. 7
A
A
A
3. Fasten the mounting bracket to the slide-out exterior wall using the five provided #10 -13 x 1 1/4”
recessed square head screws (Fig. 8).
Fig. 8
Falling slide topper access brackets can cause personal injury, product and/or property damage.
Slide topper access brackets are installed loose on the access plate until nal installation. Make sure
access brackets are secure enough to prevent falling from the access plate.
To Next Page
Loading...
