Lippert Solera 5000 Series - Secure Access Plate Screws; Manage Roll Tube Spring Tension; Install Access Bracket Screw Cover

Rev: 06.01.23 Page 8 CCD-0007029
5. Using at least two people, feed the polycord (Fig. 12A) on the fabric through the awning rail channel
(Fig. 12B).
6. Feed one of the extension rods (Fig. 13A) into an access bracket (Fig. 13B). By pulling the extension
rod all the way into the access bracket, the opposite end extension rod can now slide into the access
bracket at the opposite end.
NOTE: If needed, the access brackets can slide left or right to assist in getting both extension rods into the
access brackets.
Fig. 12
B
A
Fabric
Fig. 13
B
A
NOTE: Make sure the side of the access bracket is flush with the side of the access plate (Fig. 14A and
Fig. 15A).
7. Install the two provided 1/4” - 20 x 1/2” set screws in the top two holes of the access bracket (Fig. 14)
if using the lower position. Install two set screws in the lower two holes of the access bracket (Fig. 15)
Fig. 14
A
Fig. 15
A
if using the higher position.