Lippert Solera 5000 Series - Install Solera Slide Topper Access Bracket

To Next Page

To Previous Page

Rev: 09.22.21 Page 6 CCD-0004407

Fig. 6

Troubleshooting

Manual Override

In the event of power loss or motor failure, the awning can be extended or retracted manually. Perform the

following procedure to manually extend or retract the awning.

NOTE: This procedure may also be performed to extend or retract the awning in the event of dry camping

or camping without a battery.

1. Lift the decorative cover (Fig. 6A) by unlatching and lifting cover up from the bottom (Fig. 6B and 6C)

exposing the manual override nut on the motor (Fig. 6D)

NOTE: The drive head assembly is always located on the right side of the awning as it is viewed from

outside of the unit.

Other manuals for Lippert Solera 5000 Series