Rev: 07.06.21 Page 12 CCD-0003657
Fig. 15
B. Align pre-drilled holes in stand-off leg (Fig. 15A) with holes in the nylon bushings (Fig. 15B).
Note: Stand-off leg has a slight miter that should angle towards the end of the rear strut assembly.
C. Insert a Phillips nut (Fig. 15C) through one side of the H-bracket and into the bushing.
D. Insert a Phillips screw (Fig. 15D) into the other side of the H-bracket and bushing, then engage the
Phillips nut.
A
B
Mitered End
of Stand-off
C
D
After installation, leg should angle in this direction.
E. Tighten Phillips screw into the Phillips nut using two Phillips screwdrivers (Fig. 16).
3. Repeat steps 1 and 2 to install the second stand-off.
Fig. 16
To Next Page
Loading...
