Rev: 07.06.21 Page 18 CCD-0003657
RF Remote Control Installation - Optional
The RF Remote Control is an optional control, but not required to be installed for the system tooperate.
Resources Required
• Cordless or electric drill or screw gun
• Appropriate drive bit
• Self-drilling wood screws
• 6 Amp short stop breaker
• DPDT reversing toggle switch (if not previously
installed)
• 3/16" insulated flag spade terminal
• 1/4" insulated spade terminal
• #10 insulated ring terminal
RF Receiver Installation
1. Select a protected location on the boat to mount the RF receiver (Fig. 26A), usually inside the helm.
2. Use an electric drill and four wood screws (not supplied) to secure the RF receiver.
Fig. 26
A
Mounting
Holes, 4X
To Next Page
Loading...
