Rev: 07.06.21 Page 19 CCD-0003657
3. Connect the battery and motor wires according to the schematic diagram shown in figure 27.
Note: If a helm-mounted switch is installed, connect it to the RF receiver as shown in the schematic (Fig. 27).
Fig. 27
Override Switch
Battery Ground (-)
Battery Positive (+)
Motor #1 White Wire
Motor #1 Dark Blue Wire
Motor #2 White Wire
Motor #2 Dark Blue Wire
Helm Switch Up
Helm Switch Down
Program Button
Status Light
NOTE RED DOT
ON OR NEAR
ONE MOTOR
TERMINAL
3/16" FLAG TERMINAL
FULLY INSULATED (4) REQ'D
DPDT REVERSING TOGGLE SWITCH
PHILMORE #30 - 125
BATTERY
POSITIVE (+)
1/4" SPADE TERMINAL
FULLY INSULATED
(3) REQUIRED
#10 INSULATED
RING TERMINAL
(2) REQUIRED
6 AMP SHORT STOP BREAKER
BUSSMAN #121A06-A2M-HD
Note: All wires to be 16 AWG.
BATTERY
GROUND (-)
AUX BAT
STATUS
LIGHT
PROGRAM
BUTTON
OVERRIDE
SWITCH
To Next Page
Loading...
