Lippert SureShade Power Bimini - Page 7

Rev: 07.06.21 Page 7 CCD-0003657
Fig. 6
4. Insert a center bow (Fig. 7A) approximately 1" into the left and right rear struts of the rear
strutassemblies.
5. Insert a center bow (Fig. 7B) approximately 1" into the left and right middle struts of the rear
strutassemblies.
3. Place each rear strut/actuator assembly onto the boat's frame/railing (Fig. 6).
Note: Proper rear strut assembly positioning is generally determined by locating the assembly so that
when the top is down, the struts are just behind the rear seats. Too far forward and the top will
interfere with rear seating; while too far aft will provide less shade to the front of the boat.
Fig. 7
Starboard
Port
B
Middle Strut
A
Rear Strut
Frame/Railing
Frame/Railing