Rev: 07.06.21 Page 8 CCD-0003657
6. Adjust the width spacing between the rear strut/actuator assemblies (Fig. 8, Dim A) until the bimini
width matches the boat’s rear frame/railing width (Fig. 8, Dim B).
Fig. 8
7. Move the port and starboard actuator assemblies (Fig. 2) forward and aft until the actuators are in-line
with each other.
A. Make sure the actuators are mounted square, level and plum to one another.
B. Make sure no actuator is mounted more than 1/4" ahead of the other (Fig. 2).
8. After properly positioning each strut/actuator assembly, use a pencil to make a line across the frame/
railing in front of the actuators (Fig. 9). Set actuator assemblies aside.
Strut/Actuator
Assembly
Frame/Railing
Dim A
Dim B
Fig. 9
To Next Page
Loading...
