Connect the power and antenna to your TV, then turn on the device. The rst time you use your
TV, the Initial Installation menu appears on the screen.
1. Select the desired language with the and
buttons and press the OK button.
2. Select your country of residence, then the type of search:
• Numeric only: the television searches for digital channels.
• Digital and Analogue: the TV set searches for analogue and digital channels.
• Analogue only: the television searches for analogue channels.
Once you have nished your settings, press the OK button to start searching.
3. You will then be asked to enter and conrm a PIN code (the selection 0000 is not accepted).
4. You can now activate the Store Mode option or the Domestic Mode option. The Store
Mode is for in-store use only. We recommend that you select the Home Mode for use in
your home. You can access this option from the Settings menu > Other Settings > Store
Mode to turn it on or o later.
5. Press the OK button on the remote control to start the automatic channel scan, in cable
mode or in antenna mode. Do not turn o the TV while initialising the rst installation.
6. After all the available channels and radio stations have been saved, the channel list will
appear on the screen. Select the channel of your choice with the and
buttons and
press the OK button twice to display this channel in full screen.
FIRST INSTALLATION
EN
45 V.1.0
To Next Page
Loading...
