LiteOn EVO 6800 Series - Page 110

107
Parameter
Name
Description
Setting Range
10: Soft Starter Output Frequency
11 :Pulse Train Input
E4-06<4>
Terminal AM
Monitor Gain
Sets the terminal AM gain.
Default: 100.0 %
Min.: -999.9 %
Max.: 999.9 %
E4-07<4>
Terminal AM
Monitor Voltage
Bias
Sets the terminal AM voltage bias.
Default: 0.0 %
Min.: -999.9 %
Max.: 999.9 %
E5:Pulse Train Input/ Output
E5-00<7>
Pulse Train Input
Function
Selection
Selects the function for terminal RP.
0 ∶Frequency Command
1 ∶ PID Feedback
2 ∶ PID Target
Default: 0
Range: 0, 1, 2
E5-01<4>
<7>
Pulse Train Input
Scaling
Sets the frequency equal to 100% frequency
in Hz.
Default: 1440 Hz
Min.: 100 Hz
Max.: 50000 Hz
E5-02<4>
<7>
Pulse Train Input
Gain
Sets the level of the input gain to terminal RP.
Default: 100.0%
Min.: 0.0 %
Max.: 1000.0 %
E5-03<4>
<7>
Pulse Train Input
Voltage Bias
Sets the level of the input voltage bias when
no signal (0Hz) is input to terminal RP.
Default: 0.0%
Min.: -100.0
Max.: 100.0
E5-04<4>
<7>
Pulse Train Input
Filter Time
Sets the pulse train input primary filter time
in seconds.
Default: 0.10 s
Min.: 0.00 s
Max.: 2.00 s
E5-05
<7>
Pulse Train Input
Minimum
Frequency
Sets the minimum frequency detected by the
pulse train input. Enabled when E5-00 = 0, 1,
2.
Default: 0.5 Hz
Min.: 0.1 Hz
Max.: 1000.0 Hz
E5-06<4>
<7>
Pulse Train
Monitor
Selection
Sets the function of pulse train output
terminal MP
0 : Frequency Command
1 : Output Frequency
2 : Soft Starter Output Frequency
3 : PID Feedback Value
4 : PID Target Value
Default: 0
Range: 0 to 4
E5-07<4>
<7>
Pulse Train
Monitor
Scaling
Sets the pulse train output frequency when
the specified monitor item is at 100%.
Default: 1440 Hz
Min.: 100 Hz
Max.: 50000 Hz
E5-08
<7>
Terminal RP
Function
0：Pulse train input
1：PWM signal input
Default: 0
Min.: 0