LiteOn EVO 6800 Series - Page 115

112
Parameter
Name
Description
Setting Range
P4: Frequency Detection
P4-00
Frequency
Detection Level
Sets the detection level and width for the
multi-function output terminal.
Default: 30.0 Hz
Min.: 0.0 Hz
Max.: <5>
P4-01
Frequency
Detection Width
Default: 2.0 Hz
Min.: 0.1 Hz
Max.: 25.5 Hz
P4-02
Frequency
Command Loss
Detection
Selection
Sets the drive operation when a frequency
command loss is detected.
0: Drive Stop
1: Continue operation according to the setting
in P4-03.
Default: 0
Range: 0, 1
P4-03
Frequency
Command at
Frequency
Command Loss
Sets the frequency command level at which
the drive runs when detecting a frequency
command loss and when L4-02 is set to 1.
Sets the value as a percentage of the
maximum output frequency set in d1-02.
(Sets the value as a percentage of the motor 2
maximum output frequency set in d1-13.)
Default: 80 %
Min.: 0.0 %
Max.: 100.0 %
P4-04
Frequency
Command Loss
Detection Time
When the frequency command falls below 90%
of the command within this detection time, the
frequency command loss will be detected.
Default: 20 ms
Min.: 20 ms
Max.: 400 ms
P4-05
Brake control
release frequency
Setting brake control release frequency range
Default: 0.00Hz
Min.: 0.00Hz
Max.: 20.00Hz
P4-06
Brake control
action frequency
Setting Brake control action frequency range
Default: 0.00Hz
Min.: 0.00Hz
Max.: 20.00Hz
P5: Fault Restart
P5-00
Number of Auto
Restart Attempts
Sets the number of times to automatically
attempt to restart the drive when detecting
GF, OVA, OVD, OVC, OCA, OCD, OCC, OH, OL1,
OL2, OT1, OT2, PF and LF1.
Default: 0
Min.: 0
Max.: 10
P5-01
Auto Restart
Fault Output
Operation
0 : Fault Output Disabled
1 : Fault Output Enabled
Default: 0
Range: 0, 1
P5-02
Fault Restart
Interval Time
Sets the amount of time between restart
attempts.
Default: 10.0 s
Min.: 0.5 s
Max.: 3600.0 s