54
4.4.4 RS-485 Communication Termination ON / OFF Switch
The default of termination resistor for RS-485 communication is OFF. Switch it to ON when the
drive is the last in a series of slave drives. Set this termination resistor on DIP switch RS485
illustrated in Figure 4.4.4.
Figure 4.4.4 DIP Switch RS-485 Termination Resistor
4.5 Connection to PC
The drive is equipped with a USB port. The drive can connect to a PC through USB cable to
manage parameter settings using LiteOn PC software.
Note: When USB connection is detected, the communication will be automatically switched
from RS485 to USB, and return to RS-485 when USB is disconnected.
Figure 4.5 Connection to PC
To Next Page
Loading...
