To Next PageTo Next PageHow to troubleshoot Lithonia Lighting Flood Light that will not come on?
If the Lithonia Lighting Flood Light won't turn on, check the following: * Ensure the light switch is on. * Replace any blown fuses or turn on the circuit breaker. * Verify the wiring is correct and check all wire connections. * Increase the motion sensor sensitivity. * Test the photocontrol function by covering the daylight sensor to see if the light turns on.
What to do if Lithonia Lighting HGX LED 2RH ALO SWW2 120 PIR will not trigger with motion?
If your Lithonia Lighting Flood Light will not trigger with motion, the sensitivity may be set too low. Try turning up the sensitivity in small steps.
Why does my Lithonia Lighting HGX LED 2RH ALO SWW2 120 PIR Flood Light stay on continuously?
If your Lithonia Lighting Flood Light stays on continuously, it might be due to the following reasons: * The motion sensor is in Manual Override mode. Follow the manual override instructions to reset it. * The sensor is picking up a heat source, such as an air vent, dryer vent, or brightly painted, heat-reflective surface. Try reducing the sensitivity. * The sensor is detecting motion caused by gusty wind. Reduce the sensitivity to mitigate this.
What to do if Lithonia Lighting Flood Light comes on for no apparent reason?
If your Lithonia Lighting Flood Light comes on for no apparent reason, consider these potential causes: * The motion sensor may be detecting movement from small animals or passing cars. Try reducing the motion sensitivity. * The sensitivity is set too high. Reduce the motion sensitivity. * The outdoor temperature is getting cooler. Reduce the motion sensitivity. * The light fixture is wired through a dimmer or timer. Do NOT use a dimmer or timer to control the light fixture.
Why is my Lithonia Lighting HGX LED 2RH ALO SWW2 120 PIR Flood Light flashing on and off?
If your Lithonia Lighting Flood Light is flashing on and off (strobing), here are a few possible reasons: * Heat or light from the lamps may be turning the light control on and off. Reposition the lamp heads so light is not reflected toward the daylight sensor. * Heat being reflected from other objects may be affecting the sensor. Reduce the sensitivity. * The sensor is in Test mode. While in TEST mode, the light only stays on for 5 seconds.
Why does Lithonia Lighting HGX LED 2RH ALO SWW2 120 PIR come on during the day?
If your Lithonia Lighting Flood Light comes on during the day, it could be because: * The light fixture/sensor may be located in a relatively dark location. In these conditions, the fixture is operating normally. Turn the daylight sensor dial to a higher sensitivity. * The motion sensor is in TEST mode. Set the MODE dial to the M1 or M5 position.
General| Brand | Lithonia Lighting |
|---|---|
| Model | HGX LED 2RH ALO SWW2 120 PIR |
| Category | Flood Light |
| Language | English |
Covers risks of shock, injury, burn, fire, and product damage during installation and use.
Details the warranty terms and registration process for the product.
Lists all included parts and necessary tools for installation.
Guidelines for choosing the optimal and safe mounting position for the fixture.
Instructions for safe electrical connections and weatherproofing the fixture.
Steps to physically attach and secure the fixture to the mounting point.
How to adjust motion detection sensitivity and light-on duration.
Explains how to manually turn the light on/off using a wall switch.
Adjusts the sensitivity of the daylight sensor to control activation.
Adjusts motion detection range and sensitivity for optimal performance.
Instructions on how to position the lamp heads for desired coverage.
How to set the desired light output brightness level.
How to choose the color temperature for the lamp heads.
Diagnoses and provides solutions for common fixture operational problems.
Information on programs, tools, and resources for contractors.
