3
WINGED ELECTRIC HEATED CLOTHES AIRER
ASSEMBLY INSTRUCTIONS
3. INSTRUCTIONS
3.1 Open the support legs, unfold the heating region and position on a stable floor.
3.2 Connect the power cord directly to the wall power outlet and turn on the power button on the control panel.
3.3 Press the temperature control button to adjust the temperature between 45° and 70°C. The heated airer will reach the
desired temperature after being on for approximately 5 minutes.
3.4 Press the power button to set the timer between 1 and 24 hours.
3.5 Hang clothes on the hanging rails.
3.6 Once finished, turn the appliance off by holding the power button then unplug from wall power outlet. Allow the heated
airer to cool before folding and storing away.
4. CLEANING AND MAINTENANCE
4.1 Before cleaning, the heated airer must be disconnected from the power source and the heating region allowed to cool
down completely.
4.2 Do not immerse any part of the heated airer in water.
4.3 Wipe the rack down with a damp cloth then use a soft cloth to dry. Do not use metal balls or scourers to clean the hanging rails.
4.4 Ensure the power cord and plug are completely dry before using again.
MADE IN CHINA
DISTRIBUTED BY:
VISY RETAIL SERVICES PTY LTD (AU): 1300 734 714
VISY BOARD LIMITED (NZ): 0800 443 058
living-elements.com.au
living-elements.co.nz
To Previous Page
Loading...