17
33.C.159.1409
Quick Guides | ICS.2
Back to start
To reset a receiver unit, hold both the A and 8-buttons (A and 1 for RF 1 units)
for about 10 seconds until all the channel lights flashes red for a brief moment.
This erases all connections to all the termostats paired to this receiver unit as
well as all other receiver units. These connections needs to be setup again for the
system to function as intended.
Remove one of the batteries for about 15 seconds to make sure the reset is
completely carried out. Mind the polarity of the batteries and make sure that it
remains the same when the battery is put back in.
1.5
2.1
Resetting Receiver Units
To Next Page
Loading...