Instruction Sheet
MP-100 Analog to Digital Converter
Input Signal Source: 4-20 mA (isolated) only.
Max Input Voltage: 42VDC
Impedance: 100 Ohms
INSTALLATION
1. Disconnect signal source supply voltage prior to
connecting your MP-100. Failure to do so may damage
the MP-100 circuit.
2. Insert the 4-pin connector into the socket on your LMI
Series A7, B7 or C7 Metering Pump. The socket is
located on the bottom right under the pump control
panel.
3. Connect the other end of the cable to your input
signal source. Polarity is:
white = positive(+); black = negative (-).
Replaces same of Rev. B 7/97
1631.C 7/99
Micropace™ Electronic Metering Control Modules
MP-100 Series Loop Control
Power Supply:
15 VDC, Supplied by
LMI pump
Ambient Temperature:
0
0
F to 140
0
F
(-20
0
C to 60
0
C)
Enclosure:
Splash & dust proof,
IP-65 rated
MICROPACE
LIQUID METRONICS DIVISION
Specifications and dimensions shown above are typical for all models.
MP-100 Typical Installation
LIQUID METRONICS DIVISION
MICROPACE
4 DIGIT MULTIPLIER
MODEL MP-500M
4 6 8 10 12 14 16 18 20
Span (range)
adjustment by
stroke length
Percent
Pump
Speed
milliAmp DC Signal
MP-100 Adjustment Range
™
8 Post Office Square
Acton, MA 01820 USA
TEL: (978) 263-9800
FAX: (978) 264-9172
http:\\www.lmipumps.com
(866) 433-6682 • (281) 359-8538 • sales@novatech-usa.com • www.novatech-usa.com
To Next Page
Need help?
General
