Lochinvar CP-M Series User Manual

69
FIGURE 13.3 SETTING PARAMETERS (ctd.)
Menu B: Hot water
B 7 L e g i o h o l d
2 M i n
Menu B: Hot water
B 8 L e g i o i n t r
0
Menu B: Hot water
B 9 D H d s c O f f 2
4 o C
Menu B: Hot water
B A D H d s c P r b 2 3
2 0 o C
Menu B: Hot water
B B D H d s c D i f 2
1 0 o C
Menu B: Hot water
B C D H d s c l n t 2 3
2 0 0 S e c
Menu B: Hot water
B D D H d s c O f f 3
4 o C
Menu B: Hot water
B E D H d s c D i f 3
8 o C
Menu B: Hot water
B F D H i s c D i f 4
5 o C
Menu B: Hot water
B G D H i d e t g r a d
3 o C
This function is not used on the CP-M+ boiler and should not be altered.
This function is not used on the CP-M+ boiler and should not be altered.
This parameter sets the differential used when the DHW v essel is controlled by a
temperature sensor. This is the temperature below the setpoint temperature which
the vessel must reach before the firing sequence will restart.
This parameter is used when the DHW vessel is controlled by a temperature
sensor. If the boiler detects an accelerated hot water demand (e.g. a drop within
1 second) the firing sequence will start even if the differential temperature has not
been reached.
This parameter sets the time period that the pasteurisation function runs for.
This parameter determines whether a pasteurisation demand takes priority over a
CH demand over the boiler. A v alue of 0 gives pasteurisation priority, a value of
1 gives heating priority.
> > > From previous page < < <
This function is not used on the CP-M+ boiler and should not be altered.
This function is not used on the CP-M+ boiler and should not be altered.
> > > Continued on next page < < <
This function is not used on the CP-M+ boiler and should not be altered.
This function is not used on the CP-M+ boiler and should not be altered.

Lochinvar CP-M Series Specifications

General

Brand	Lochinvar
Model	CP-M Series
Category	Boiler
Language	English