Loewe Subwoofer 800 - Page 8

19 -
Deutsch English Français Italiano Español Nederlands
Connection
Connecting the speakers to the subwoofer
Connect the speaker cable to the speaker according to the appropriate installation
instructions. One of the two wires of the speaker cable is marked black in the usual
way. Connect this black marked cable respectively with the black screw terminal
to the subwoofer  (connection diagram see figure right) and the black terminal
on the speaker.
Turn the screw connection of the respective terminal on the subwoofer anticlockwise
about 5 turns for this. Feed the wire end into the screw terminal (top right hand
side) and close the screw terminal in clockwise direction.
Connect the unmarked wires with the red terminals.
Laying the cables
Feed all cables down through the slot in the housing of the subwoofer. Bundle the
cables with the Velcro tape provided.
You can feed the cables tidily out of the subwoofer with the fabric hose available
as an accessory.
AudioLink
Line In
Speaker
Out
Power Mode
Left
Center
Right
Left Right Left Right
230V~50/60Hz
Left
Phase
Equaliser
Crossover
Frequency
Bass
Intensity
180°
-3dB
+6dB
50Hz
250Hz
min
max
0°
Subw Right
Rear
Front
OFF ON Auto Manu.
Front Rear
Connecting the subwoofer to the mains
Plug the mains plug of the subwoofer into a 230 V AC socket.
AudioLink
Line In
Speaker
Out
Power Mode
Left
Center
Right
Left Right Left Right
230V~50/60Hz
Left
Phase
Equalizer
Crossover
Frequency
Bass
Intensity
180°
-3dB
+6dB
50Hz
250Hz
min
max
0°
Subw Right
Rear
Front
OFF ON Auto Manu.
Front Rear
Front
left
Front
right
Rear
left
Rear
right
Loewe Subwoofer 800