Logitech BCC950 Quick Reference Guide

LOGITECH BCC950 CONFERENCE WEBCAM SET-UP
QUICK REFERENCE GUIDE V1
© The content of this document is the copyright of Nottinghamshire Health Informatics Service (NHIS). Unless stated otherwise, you may only use this material for your
personal use, private study, research or in-house use. You must not copy, distribute or publish any material produced by NHIS unless formal permission is obtained
from the copyright holder
The Logitech BCC950 is NOT a stand-alone unit and will need to connect to a laptop or PC via a USB cable and an AC
power outlet. The 4 main components which comprise the BCC950 are shown below:
Together, these components can be used in either base mode, or extended to eye-level:
SETTING UP THE UNIT
Power on the laptop or computer you will be using with the webcam.
.
Note: if you wish to use the eye-level stand, you MUST disconnect the AC power BEFORE attaching or removing the
webcam. You can now launch the video conferencing software on the computer.
Please ensure the stand is fitted using the correct orientation, as shown below:
Top Stand Connector: Bottom Stand Connector:
This is the base unit,
which connects via
USB to the computer
This is the
webcam
The power supply
plugs into the
base unit
This is the eye-
level stand for the
webcam
This is the
webcam fitted
to the base unit
This is the
webcam with
the eye-level
stand fitted
Attach the Webcam
to the Base Unit
Connect the power supply
to the rear socket of the
base unit and an AC outlet
Connect the base
unit to the computer
with the USB cable
Attach the
stand if required

Logitech BCC950 Specifications

General

Brand	Logitech
Model	BCC950
Category	IP Camera
Language	English