Logitech G9X - Logitech G9 x Custom-Color LED Display; Understanding LED Display Settings

12
English
Custom-Color LED Display
Underneath the dpi adjust buttons, your G9x has an LED
display. The LEDs indicate both dpi and on-board memory
prole settings.
The G9x allows you to change the color of the LEDs to
your preference using SetPoint
®
software. Choose your
favorite colors from a broad color spectrum. You can assign
a different color to each prole so you can always tell which
prole is enabled by the color of the LEDs.
LED Display Settings
LED settings will always be indicated in ascending order from left to right. The lighting scheme will
change depending on the number of dpi and prole settings you choose to have, but in all cases,
the LEDs will light up to indicate lowest setting on the left to highest setting on the right.
This LED display by default will indicate what dpi setting is active (DPI Mode). When the Prole button
(bottom of the mouse) is being pressed (Prole Mode), the LEDs will indicate which prole setting stored
in on-board memory is enabled. In this Prole Mode, the running man LED will blink to show you are able
to actively change the prole setting. When the mouse is in DPI mode, pressing the + and – buttons will
change dpi setting. When in Prole Mode, these same buttons will change the Prole setting.
Note: When Application Detection is enabled in SetPoint
®
, the LEDs will only indicate dpi settings and not
prole settings.