Before we proceed further, let's go thru the servo selection feature for LTG-2100T.
Get into gyro setup by pressing the MENU button and holding on to it until the LED goes
to the first setting. Let go. You will see the green LED at SERVO SPEED and a red LED
above.
The rudder stick is used to shift the red LED left and right to desired positions for setup.
Experiment with it and you will understand immediately.
To change move the red LED to the suitable position, hold the rudder stick one direction
or the other and press the MENU button once. You will notice the red LED shift a
position.(if not, hold the other direction and press the button). Choose the suitable servo
type selection
To Next Page
Loading...