Leave the transmitter alone now.
Hold the tail and move it to it's left, you should notice the tail blades will tend to angle
towards Full LEFT.
Hold the tail and move it to it's right, you should notice the tail blades will tend to angle
towards Full RIGHT.
If it's behaving the correct way, leave it alone.
If it is opposite, we will need to reverse the gyro sensing.
Enter gyro setup just like before, press and hold MENU button for a few seconds, until it
enters setup mode. Let go and press repeatedly until the green LED gets to DIRECTION.
Use rudder stick to move the red LED to the 'other' position. Gyro sensing direction is
changed.
Exit gyro setup mode.
Your throttle curve is expected to be capable of maintaining reasonable headspeed for
good hovering.
Do a test hover and watch out for the tail, it is very likely to drift to either direction. Land
and adjust the servo mount/ball links and test hover again.
Repeat this process as many times as required to get a close to perfect mechanical neutral
so you can hover without the tail drifting. The better you can achieve this at this stage,
the better your tail will work.
Now that the mechanical setup is done, let's proceed to utilise the feature function of the
To Next Page
Loading...
General