Loglift 105Z CE - 1.2. Indications in the Operators Manual

1.1.2. The Machinery Directive 2006/42/EC
• Business name and full address where the crane is
manufactured (2):
Factory addresses:
Cargotec Sweden AB Hiab SE-824 83 Hudiksvall
Sweden
Cargotec Poland Sp. z o. o. Ul. Metalowa 2, 73-110
Stargard Szczecinski, Poland
• The Declaration of Conformity, delivered with the crane
contains (1):
• Description and identification of the timber handling
crane (3):
Mark
Type: see chapter Identification of the timber handling
crane.
Serial number
Manufact. year
Declaration of which provisions the timber handling crane
fulfils.
• Name and address of the person authorised to compile
the technical file (4):
Name
Address
• Identity and signature of the person who drawn up the
declaration (5):
Name
Position
Date and Signature
1.1.3. Description of Loglift 105Z
The Loglift 105Z is manufactured by Hiab to load cut-to-length timber with a grapple. Usually
installed on a timber truck, either in the rear or behind the cab, it is not intended for hook duty
.
The Loglift 105Z is available in many versions with a wide range of accessories, and fulfills the
requirements of the European Machinery Directive as specified by the standard EN12999.
On the serial number plate, you can find information on the crane type and on the manufacturer.
NOTE
The exact technical information for your crane is shown in "Technical Data".
1.2. Indications in the Operator’s Manual
What must you do and not do?
The following indications are used in the Operator’s Manual:
Declaration of conformity with the
Machinery Directive 2006/42/EC
We ............................................
............................................
.....................................
hereby declares that the timber handling crane:
Mark: .....................
Type: .....................
Serial number: ....................
Manufact.year: ....................
• complies with the provisions of the machinery directive
2006/42/EC;
• also complies with the provinsions of the directive on electro-
magnetic compability 2004/108/EC as amended;
• complies with the harmonised standard
EN 12999:2011/A1:2012.
Technical file in accordance with Directive 2006/42/EC, Annex
VII A is compiled by:
Name: .........................................
Adress: ..........................................
...........................................
This declaration is drawn up by:
Name: .................................
Position:.................................
XXXXXXX .................
…………………………………………………………………
཰
ཱ
ི
ཱི
ུ
Introduction
Loglift 105Z CE 7